Femi 783 - User Manual

Questions and Answers

J
John MartinezAug 6, 2025
What to do if my Femi 783 Saw motor does not work?
- P
  Peter PowellAug 6, 2025
  If the motor of your Femi Saw isn't working, here are a few things to check: * First, examine the electric panel fuses and replace them if they're blown. * Second, verify there's voltage in the mains system. * Third, see if the overload cutout has tripped; if so, release the run button and wait a few minutes for it to reset. If these steps don't solve the issue, it could be a defective motor, power cable, or plug, which should be inspected by specialized personnel.
C
Crystal JohnsonAug 12, 2025
Why does the overload cutout trip on my Femi 783 Saw?
- G
  gmcfarlandAug 12, 2025
  The overload cutout on your Femi Saw might trip due to several reasons: * The motor may be overheating, so check that the motor air intakes are clear. * Excessive cutting pressure can cause a motor overload; try performing the cut with the correct pressure. If neither of these solves the problem, it could indicate a motor breakdown, which requires inspection by specialized personnel.
R
Ryan GonzalezAug 17, 2025
What to do if cut finish of Femi Saw is coarse or corrugated?
- R
  Robert ChangAug 17, 2025
  If the cut finish with your Femi Saw is coarse or corrugated, consider the following: * The blade may be worn or unsuitable for the material's thickness. Check the cutting parameters (blade toothing, cutting speed). * Excessive cutting pressure can also cause this issue; try decreasing the pressure. * Incorrect eccentric blade-guide adjustment could be the culprit, so check its adjustment. * Excessive wear of the pulley rubber linings could be the reason. Specialized personnel should check the pulleys and replace them if necessary.
D
Denise KnightAug 21, 2025
Why is my Femi 783 Saw cutting angle inaccurate at 90° - 45°?
- G
  Gregg WellsAug 21, 2025
  An inaccurate cutting angle at 90° - 45° on your Femi Saw is likely due to the inaccurate setting of the H and K retainers. To resolve this, unloosen the fastening screws and reposition the retainers.
D
Debbie WalkerAug 27, 2025
What to do if my Femi 783 Saw has inaccurate cut squaring?
- T
  Thomas ReynoldsAug 27, 2025
  If you're experiencing inaccurate cut squaring with your Femi Saw, consider these potential causes: * Excessive cutting pressure, especially on pipes and section bars, can lead to this. Decrease the cutting pressure. * Incorrect blade toothing for the material being cut. Check the cutting parameters (blade toothing, cutting speed). * Incorrect adjustment of the eccentric and sliding blade-guides. Check blade-guide adjustment. * Incorrect cutting speed for the material. Check piece positioning and clamping in the vice. * The piece is wrongly positioned in the vice or there's poor blade tension. Check blade tension.
T
Theresa KennedyAug 31, 2025
How to fix a Femi 783 Saw blade that slips on the pulleys?
- P
  Philip MitchellAug 31, 2025
  If the blade on your Femi Saw is slipping on the pulleys, it could be caused by oil or grease. Check the blade. Also, never use any type of lubricant or coolant for the cutting operations; specialized personnel should check and, if necessary, replace the pulleys.