Femi TR 250-i - User Manual

Questions and Answers

C
Christine MitchellAug 12, 2025
What to do if my Femi TR 250-i Saw motor is not working properly?
- D
  Daniel NicholsAug 12, 2025
  If the Femi Saw motor isn't working, there could be several reasons. It might be a faulty motor, power cable, or plug, in which case you should have it checked by expert personnel. Never attempt to repair the motor yourself, as it could be dangerous. Also, check the fuses and replace them if necessary. Finally, if it's a version with a brushed motor, damaged brushes could be the problem, and you should have them replaced by expert personnel.
P
Paul GarciaAug 16, 2025
Why does the Femi TR 250-i Saw motor tend to overheat?
- E
  Elizabeth JuarezAug 16, 2025
  The Femi Saw motor may overheat due to motor overload, so avoid overloading the motor during cutting operations. Another possible cause is insufficient motor cooling. In this case, remove the dust from the motor to achieve a correct flow of cooling air.
D
Diana BoltonAug 20, 2025
What to do if my Femi Saw motor does not reach full power?
- E
  evansalexisAug 20, 2025
  If the Femi Saw motor does not reach full power, it may be due to the mains system circuits being overloaded by lights, utilities, or other motors. To resolve this, avoid using utilities or other motors on the same circuit to which the machine is connected.
C
Cynthia ThompsonAug 23, 2025
Why does the motor on my Femi TR 250-i Saw start slowly?
- E
  Emily GutierrezAug 25, 2025
  If the Femi Saw motor starts slowly or doesn't reach operating speed, it could be due to low power supply voltage. Ask the power supply company to check how much voltage is available. It could also be due to damaged windings, in which case you should have the machine motor checked by expert personnel.
M
Miguel GarrettAug 27, 2025
How to fix a noisy Femi Saw motor?
- K
  Kristie MartinAug 27, 2025
  If the Femi Saw motor is making too much noise, it could be due to a faulty motor or damaged windings. In either case, have the machine motor checked by expert personnel.
B
Brad MccartyAug 31, 2025
Why is the cutting finish rough or uneven with my Femi Saw?
- J
  Jeffrey BatesAug 31, 2025
  A rough or uneven cutting finish with the Femi Saw can occur if the blade is worn down or the teeth are not suitable for the thickness of the material being cut. Have the blade sharpened by a specialized company. Also, check the teeth on the blade to ensure they are suitable.
D
Deborah LewisSep 4, 2025
How to restore cutting capacity in my Femi TR 250-i?
- M
  Margaret SampsonSep 4, 2025
  A reduction in cutting capacity in the Femi Saw can occur if the blade has been sharpened many times, thus reducing its diameter. To address this, adjust the limit switch for head lowering.
G
Grace MejiaSep 8, 2025
What causes splintering of the cut workpiece when using my Femi TR 250-i?
- G
  griffithanthonySep 8, 2025
  Splintering of the cut workpiece when using the Femi Saw can be caused by the blade’s teeth not being suitable for the workpiece being cut. Check the correct teeth to be used.