Need help?Do you have a question about the Fender PR 845 and is the answer not in the manual?
General| Type | Stereo Receiver |
|---|---|
| Tuning range | FM, MW |
| Power output | 2 x 45W (RMS at 8 ohms) |
| Frequency response | 20Hz to 20kHz |
| Input sensitivity | 150mV |
| Speaker load impedance | 8 ohms |
Flip open cabinet latches to access speaker cabinets and mixer section.
Elevate speakers on stands or tables and position them for stereo separation.
Store power cord and speaker cables in the rear mixer compartment.
Connect speaker cables to mixer and speakers, then connect power cord to mixer and outlet.
Connect audio sources and set initial volume/reverb to minimum.
Power on the system and set the master volume to 1/4.
Set channel levels, tone, and reverb for optimal sound and to avoid clipping.
Master Volume, Signal Level Meters, Signal/Clip LED, Channel Controls, and Tone/Reverb adjustments.
Various inputs (Mic/Line, Instrument, Stereo) and Bluetooth pairing.
Headphone, Mono, Sub outputs, and Power/Protect status indicators.
Select operating voltage and turn the system on/off.
Connects the power cord and houses the fuse for protection.
Connects the included speaker cables to the left and right speakers.
To Next Page
