Need help?Do you have a question about the Fender SRM 6302 and is the answer not in the manual?
Controls the amount of signal sent to the overall effects mix. Setting to 0 results in a dry output.
Adjusts the amount of high frequency boost or cut in the channel. Flat when set to 0.
Adjusts the amount of middle frequency boost or cut in the channel.
Adjusts the amount of low frequency boost or cut in the channel.
Controls the amount of signal sent to the monitor mix. Setting to 0 sends no signal.
Adjusts the volume control of the individual channel for the main mix.
1/4 inch TRS balanced input for line-level sources like keyboards or drum machines.
Three-pin XLR balanced female connector for low-impedance microphones.
Unbalanced line-level output for feeding external power amplifiers or mixers.
Input for feeding an external signal to Power Amp 1, overriding internal connection.
Unbalanced line-level output for feeding monitor systems.
Input for feeding an external signal to Power Amp 2, overriding internal connection.
Output for external effects units or footswitch control of internal reverb.
Input for receiving signal from external processing devices.
Switches the graphic equalizer between the main and monitor buses.
Nine-band graphic equalizer for adjusting frequencies across the audio spectrum.
Activates +48V DC Phantom Power for condenser microphones.
Illuminates when the SRM 6302 / 8302 unit is powered on.
Assigns the second power amplifier to the main or monitor bus.
Adjusts tape/effects signal level sent to the monitor mix.
Adjusts tape/effects signal level sent to the main mix.
Controls the main output volume affecting Main Out, PA1, and PA2.
Adjusts reverb signal level sent to the monitor mix.
Adjusts reverb signal level sent to the main mix.
Controls the monitor output volume affecting Mon Out, PA1, and PA2.
Adjusts signal level for effects out and reverb drive.
Adjusts the tape out signal level, fed by the Main Out signal.
RCA input jacks for connecting tape players or CD players for stereo input.
RCA output jacks for connecting to a tape recorder.
Speaker-level outputs for main or monitor enclosures, minimum 4 ohms impedance.
Turns the AC power ON and OFF for the unit.
Grounding type supply cord to reduce shock hazard; ensure proper ventilation.
To Next Page
General