Fenix TK32 User Manual

Fenix TK32 Flashlight User Manual
400 meters (437 yards) from a palm-sized light? No, you are not mistaken. The TK32
Flashlight drives deep downrange to 400 meters with 900-lumen output. Balanced for
easy carry, the light also features red, green and blue LEDs and the dual tail switch
system is all you need to control this multi-color flashlight.
Technical Parameters
ANSI/NEMA
FL1
Turbo High Mid Low
OUTPUT 900
lumens
400
Lumens
130
Lumens
10
Lumens
RUNTIME 1h30min 3h45min 13h 150h
DISTANCE 400m
（
Max
）
INTENSITY 40000cd
（
Max
）
IMPACT
RESISTANT
1m
WATER
RESISTANT
IPX-8 ( 2 meters underwater)
ACCESSORIES Holster, lanyard and spare O-ring
Notice: The above-mentioned parameters (lab-tested by Fenix using ARB-L2S 18650 Li-
ion battery) are approximate and may vary between flashlights, batteries and
environments.
The flashlight will drop down into the high brightness level after working about 15 minutes
in the Turbo mode. Therefore, the runtime of Turbo output is an accumulated time.
● Utilizes Cree XM-L2 (U2) LED with a lifespan of 50,000 hours
● Integrated Red, Green and Blue LEDs with 100mW output
● Uses one 18650 rechargeable Li-ion battery or two CR123A batteries
● 159 mm (Length) × 25.4 mm (Body Diameter) × 52mm (Head Diameter)
● 180-gram weight (excluding batteries)
● Digitally regulated output - maintains constant brightness
● Low-voltage warning function to remind users of low power

Fenix TK32 Specifications

General

Magnet	No
On/off switch	Yes
Product color	Black
Flashlight type	Hand flashlight
Housing material	Aluminum
Protection class	III
Lamp type	LED
Bulb power	10 W
Lamps quantity	1 lamp(s)
Service life of lamp	50000 h
Number of power levels	4
Light beam distance (max)	400 m

Weight and Dimensions

Width	254 mm
Height	159 mm
Weight	180 g

Summary

Technical Parameters

Flashlight Operation

Momentary-on Operation

Slightly press and hold the tail power switch for momentary activation.

Constant-on Operation

Fully press the tail power switch to turn the light on or off.

Brightness Output Selection

Press the tail mode switch to cycle through brightness levels: Turbo>Low>Mid>High.

Colored LED Operation

Press and hold mode switch for colored LEDs; cycle through Red, Green, Blue.

Instant Red Light Access

When light is off, press and hold mode switch for momentary red light.

Intelligent Memory Circuit

Flashlight remembers last used white light and colored LED settings.

Over-heat Protection

Turbo mode drops to High after 15 mins to prevent overheating.

Low-voltage Warning Function

Light downshifts brightness or blinks when battery is low.

Battery Specifications

Battery Replacement

Usage and Maintenance

Product Warranty

Product Registration