FENIX PD36R RECHARGEABLE FLASHLIGHT
Operating Instructions
PD36R Switches
The tail switch is the tactical switch, and the side switch is the functional switch.
PD36R ON/OFF
Tap
Slightly tap the tactical switch to momentarily turn on the light, release it the light will go out.
Fully press
Fully press the tactical switch to constantly turn on the light, press once again to turn off the light.
PD36R Output Selection
With the light switched on, single click the functional switch to cycle through Turbo→Eco→Low→Med→High.
Strobe
With the light switched on, press and hold the functional switch for 0.5 seconds to enter strobe, click once again to
return back to General mode.
Intelligent Memory Circuit
The light memorizes the last selected output excluding strobe. When turned on again the previously used output will be
recalled.
Battery Replacement
Unscrew the light head to insert the battery with the anode side (+) towards the light head, then screw the light head
back on.
Boot-up Battery Level Indication
Each time the light is turned on, the battery level indicator in the middle of the switch will automatically display the
battery status for 3 seconds.
• Green constant on: 85% – 100%, saturated
• Green flashes: 50% – 85%, sufficient
• Red constant on: 25% – 50%, poor
• Red flashes: 1% – 25%, critical
Note: This only works with Fenix ARB-L21-5000 21700 rechargeable Li-ion battery.
To Next Page
Need help?
General
Weight and Dimensions
