Fenix UC30 2017 User Manual

Fenix UC30 2017 Flashlight
Technical Parameters
ANSI/PLATO FL1
General Mode
Strobe
Turbo High Med Low Eco
Output
1000
Lumens
350
Lumens
150
Lumens
50
Lumens
5
Lumens
1000 Lumens
Runtime
*1h
25min
3h
20min
8h
45min
28h
25min
150h /
Distance
253m 156m 101m 58m 21m /
Intensity
16,000cd 6,080cd 2,550cd 840cd 110cd /
Impact
Resistance
1m
Waterproof
IP68, underwater 2m*
Notice: The abovementioned parameters (lab-tested by using Fenix ARB-L18-2600 rechargeable
Li-ion battery) may very between flashlight, batteries and environments.
*Due to the protective setup, the light will automatically lower its brightness from Turbo to High
after working 3 minutes. Therefore, the runtime of Turbo mode is the accumulated time without
time-limited downshifting. Check the following Runtime Graph to see the actual duration when
time-limited downshift works.
**Be sure to replace the USB cover to guarantee the waterproof ability of the flashlight.
 Cree XP-L HI V3 LED with lifespan of 50,000 hours
 Powered by one 18650 rechargeable Li-ion battery or two CR123A Lithium batteries
 Micro USB charging

Fenix UC30 2017 Specifications

General

Max Output	1000 lumens
Impact Resistance	1 meter
Waterproof	Yes
Body Diameter	25.4 mm
Charging Time	4 hours
Battery Type	18650, CR123A
Water Resistance	IPX8
Dimensions	25.4mm (diameter)
LED	Cree XP-L
Modes	Turbo, High, Medium, Low, Eco, Strobe
Material	aircraft-grade aluminum

Summary

Technical Parameters

Accessories

Operating Instruction

ON/OFF

Press and hold the side switch over 0.5 seconds to turn ON/OFF the light.

Output Selection

Single click the side switch to cycle through Turbo, Eco, Low, Med, High modes.

Strobe

Press and hold the side switch for 1.2 seconds to enter strobe mode.

Intelligent Memory Circuit

The light memorizes the last selected brightness level on General mode.

Overheat Protection

The light automatically downshifts to High output after 3 minutes on Turbo to reduce temperature.

Low-voltage Warning

Activates when voltage drops below 3.3V, indicating low battery status.

Battery Level Indication

Charging

Battery Specifications

Battery Replacement

Usage and Maintenance

Warning