Fenix LD05 User Manual

Fenix LD05 V2.0 Flashlight
Technical parameters
ANSI/PLATO FL1 High Med Low UV Light
Output
100 Lumens 25 Lumens 5 Lumens 200mW
Runtime
Alkaline
Battery
1h 40min* 7h 50min 70h 9h
Ni-MH
Battery
2h 10min* 6h 40min 36h 7h
Distance
54m 34m 22m /
Intensity
730cd 290cd 120cd /
Impact
Resistance
1m
Waterproof
IP68, underwater 2m
Note: The abovementioned parameters (lab-tested by Fenix using AAA alkaline and Ni-MH
batteries) may vary between flashlights, batteries and environments.
*The runtime of High output is the accumulated time when time-limited downshift activates.
 Cree XQ-E HI LED (90-CRI/ 3000K), with lifespan of 50,000 hours
 Fitted with 365nm UV LED
 Powered by two AAA batteries
 135mm Length x 13.5mm Diameter
 29.7g (excluding batteries)
 Digitally regulated output maintains constant brightness
 Reverse polarity protection to protect from improper battery insertion
 Tail switch for one-handed activation and output selection
 Made of durable high-strength and oxidation-resistance aluminum and stainless steel
 Premium type HAIII hard-anodized anti-abrasive finish
 Optimal quality optical lens
Operating Instruction
ON/OFF ①
Fully press the tail switch to turn on/off the light.
Output Selection ①

Fenix LD05 Specifications

General

Light Output (Low)	30 lumens
Light Output (High)	300 lumens
Impact Resistance	1 meter
Material	Aircraft-grade aluminum
Switch Type	Tail switch
Mode Memory	Yes
Water Resistance	IP68
Modes	High, Medium, Low
LED	Cree XP-G2
Max Output	Fenix LD05 300 lumens

Summary

Technical Parameters Overview

Operating Instructions

On Off Function

Fully press the tail switch to turn the flashlight on or off.

Output Selection

Tap the tail switch to cycle through Low, Medium, High, and UV brightness levels.

Battery Specifications

Battery Replacement

Unscrew the head to insert batteries with the anode side (+) towards the light head.

Intelligent Memory Circuit

The light recalls the last used brightness level when turned on.

Time-limited Downshift

On High output, the light steps down in brightness after 3 minutes to reduce heat.

Usage and Maintenance

Product Inclusion and Warning

Safety Warning

This flashlight has high-intensity UV light and can cause eye damage. Avoid shining directly into eyes.