• The electric circuit is broken.
• Have the electric circuit repaired.
• Wiresinthemainsplugorinthesocketare
loose.
• Have socket and plug checked or repaired.
• The switch is faulty.
• Have the switch replaced.
2. The operating switch is switched on, but
unusual noises can be heard, the motor is
not working or only very slowly.
• Switch contact has fused.
• Have the switch replaced.
• Component jammed.
• Have the electric tool checked or repaired.
• Too much thrust, as a result the motor is
dragging.
• Use less thrust during the task.
3. Motor gets hot.
• Foreign substances have got inside the motor.
• Have the foreign substances removed.
• Lack of or contaminated lubricating grease.
• Have lubricating grease applied or
replaced.
• Pressure too high.
• Use less thrust during the task
• Planing tool blunt.
• Replace the planing tool.
4. The motor is working, but the planing tool
is not moving.
• V-belt worn.
• Have V-belt replaced.
5. Frequent or strong sparks on the
commutator.
• Short circuit on the armature.
• Have the armature replaced.
• Carbon brushes worn out or jammed
• Have the carbon brushes checked.
• Rough running of the commutator.
• Have the surface of the commutator
cleaned or ground
For your own safety, never remove parts
or accessories of the electric tool during
operation. In case of fault or damage
have the electric tool repaired only by a
specialist workshop or by the
manufacturer. Use only original spare
parts and original plane blades!
Maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
These appliances are designed to function without
difficulty for a long time and to require minimum
maintenance. You will prolong the appliance’s life
by cleaning it regularly and using it correctly.
Cleaning
Clean the housing regularly with a soft cloth,
preferably every time it is used. Keep the air vents
free of dust and dirt. Remove stubborn dirt with a
soft rag moistened in soapy water. Do not use any
solvents such as petrol, alcohol, ammonia, etc. as
such substances can damage the plastic parts.
Lubrication
The appliance does not need any extra lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Warranty
Read the terms of warranty on the separate
warranty card which is enclosed. Please contact
the service address if you have any questions
regarding accessories and/or batteries.
To Next Page
Loading...
