Need help?Do you have a question about the Ferm PPM1008 and is the answer not in the manual?
General| Voltage | 230 V |
|---|---|
| Power input | 1500 W |
| Max. material removal thicknessing | 2 mm |
| No load speed | 9000 RPM |
| Max. thicknessing height | 120 mm |
Details common symbols used in the manual and on the machine for safety and identification.
Pre-operation checks and setup procedures for safe and effective use of the planer.
Detailed steps for adjusting depth, securing workpiece, switching on, and planing techniques.
Using the V-groove for chamfering workpiece edges.
Using the rebating depth stop for creating rebates on workpieces.
Instructions for attaching and adjusting the rip fence for cutting parallel edges.
Procedure for safely detaching the plane blade and its holder from the machine.
Steps for correctly fitting a new plane blade and securing it in place.
Troubleshooting guide for common operational problems and their solutions.
Guidelines for regular cleaning of the planer housing and air vents.
Information regarding the lubrication requirements of the appliance.
To Next Page
