Fermax DUOX Video Direct Outdoor Panel

Pag 55
Upon making a call,
• If a Panel is configured as Block it only allows the call to the configured Block (BB).
Block 25, if pressing 1 +


 the following calling code is generated 250001.
• If a Panel is configured as Block+Sub-block it only allows the call to the configured
Block (BB) and Sub-block (SS).
Block 12 / Sub-block 03, when pressing 1 +


 generates the following calling code
120301.
• If the Panel is configured asGeneral Entrance
If you press 1 +


 you generate the calling code 000001.
Upon making a call, if the selected terminal is in the installation and available (it may be
in conversation with another street panel) it is monitored via a characteristic calling one.
If the marked terminal is not available, a call error tone sounds (beep-bop).
NOTES:
-If a shorter code is entered, it is filled in with “0” to the left.
- Use the ‘A’ key to delete the entered sequence.
- The ‘0’ entered on the left are considered.
- Once the call to a residence is made, and it is proven to exist and not busy, if you press
the key again a new call is made to the same home. After 30" the last home
marked is not memorised.
Opening the door with a code.
You can enable a lock-release code for all residents. This is a 4 digit code ranging from
0000...9999 and can be entered by pressing A when the panel is in stand-by and then the
4 digits.
Opening code: A + XXXX
NOTES:
-This option is deactivated by default. To deactivate the opening code you must enter
the value AAAA in position 08, see “Street panel configuration” on the following page.
- If you press the A key before entering the fourth digit of the opening code, the opera-
tion is cancelled. An error tone (beep-bop) indicates that the access code has been
cancelled.
- The open-door relay activation time is the same as when opening from the home.
- The open code can not be the same as the programming code established in the
system. If entered it is indicated via an error tone (bop).