Fermax iLoft DUOX

Page 19
Door lock-release
When a call is received from the entry panel, you can open the
door at any time, by pressing the
button.
Controlling audio volume and cancelling the ringtone
The telephone allows for call ringtone volume regulation and
the output audio volume. Starting from standby mode, use
the controller to adjust the call volume to any setting between
the maximum and minimum levels.
If during call volume regulation the control is taken down to the
lowest volume, it provokes the call disconnection.
In this mode
the led remains fl ashing. To reactivate the ringtone, you must
move the controller above the minimum level.
The disconnection option affects all ringtones generated by
the telephone:
Notes:
- The red led fl ashes when a call is being received whether enabled
or not.
- If the call is disconnected, the call extension function or light and
doorbell activation is not affected. The connected device sounds.
- For more operating information: See"Call Volume Regulation".
POTENTIOMETER
In conversation (audio activated). If picked-up, it can occur
during the conversation with an entry panel. The lock is released
on the panel that called.
Upon receiving the call (audio not activated). If the phone is
not answered you have 30 seconds to open the door.
Call to Guard Unit
This is done by pressing the
button when the telephone is in standby and hung-up.
The call to Guard Unit is made to the Guard Unit that is activated for the block in which
the telephone is, sounding a beep when the confi rmation is received from this Guard Unit.
If the block’s guard unit is not active (night mode) the call to a guard unit is made to the
general guard unit if there is one active. If the installation does not have an active guard
unit, the phone will not beep.