Fermax iLoft DUOX

Page 18
While in simplex conversation mode press the button to speak and release to listen
-Push to Talk).
· Upon pressing the call to Outdoor Panel button, a call tone is produced both on the
outdoor panel and the telephone.
· On receiving a call on the telephone the user has 30 seconds to answer. The red led
fl ashes during this time to indicate a pending call.
· Press and release the
button, the blue led will fl ash, the input audio will remain active
(you will hear the panel on the telephone).
· From this point every time you press the
button, the output audio channel will activate
(you will hear the telephone on the panel) and a constant blue led will light up.
· Upon releasing the
button the input audio channel will activate (you will hear the panel
on the telephone) and the intermittent blue led will light up.
·
Hung-up: press the button to fi nish communication, if not, the conversation fi nishes in
90 seconds. When fi nished the blue led light turns off again and the red light is turned on.
· Auto-Start: With the telephone on standby, press and release this button
(short press),
the blue led fl ashes. This function is possible with the panel in the same block; if the panel
is in standby and programmed as "0"; and if there is a conversation channel available, (if
it isn’t available, upon hanging up you will hear a busy tone for 15 seconds). Auto-start:
Only with video outdoor panel.
1
65
4
30"
¸
3
987
2