Page 17
2. Press the F1 button and the button si-
multaneously for 15 seconds until you hear
a double tone (BEEP BEEP) and release.
After 5" you hear a BEEP and after 10" you
hear a BEEP BEEP.
Note: Since reset deletes the programmed address,
when the LED is blinking it indicates that the reset
has completed.
iLOFT DUOX TELEPHONE OPERATIONS
Answering a call
· Upon pressing the call button, a call tone is produced both on the outdoor panel and
the telephone.
· On receiving a call on the telephone the user has 30 seconds to answer. The red led
fl ashes during this time to indicate a pending call.
· Audio activation:
Upon pressing and releasing the button within this time communication
is established with the entry panel that has made the call , (constant blue led).
· Hang-Up:
Press the button to end communication, if not, the conversation will be dis-
connected after 90 seconds. When fi nished the blue led light again turns off and the red
light is turned on.
· Auto-Start: With the telephone on standby, press and release this button
(short press),
the blue led lights up. This function is possible with the panel in the same block; if the panel
is in standby and programmed as "0"; and if there is a conversation channel available, (if
it isn’t available, upon hanging up you will hear a busy tone for 15 seconds). Auto-start:
Only with video outdoor panel.
Notes:
- If the phone is not programmed, the auto-start will not function.
- If you made a call from the 00 panel to another home and you are within the waiting time to pick-up
(30 seconds), you can not communicate with the 00 panel.
15"
¸
+
1.BEEP
5"
¸
15"
¸
2.BEEP BEEP
To Next Page
Loading...
