Pag. 22
Technical Book
MDS-ADS
MDS-ADS
NOTES:
Remember that if you want to do the programming from an MDS panel (guard units included), the ADS
decoder will need to be programmed previously, as explained in the section "Programming the ADS
DECODER" (Telephone 3: FFFF).
First, make a call from the outdoor panel used to any address in the block, in order to activate the audio
channel.
The telephones programmed with the sub-option "ATTENDED/MANUAL" will need one person at the
panel and another going from house to house. A conversation may take place between the person at the
outdoor panel and the one in the apartment to indicate which apartment they are in.
The telephones programmed with the "SEQUENTIAL/AUTO" sub-option must have consecutive numbers
and all that is required is one person to go from house to house.
NOTE: 1-> On the panel display the message "Press open door button on telephone"
appears but in reality the programming switch/jumper on the monitor/telephone must be changed to
the ON position (in the ADS Basic Telephone Ref. 2406, the programming button must be pressed).
NOTE: 2-> On the panel, the actual number of the the telephone will appear, determined by the value
0000, if it has not yet been programmed.
MDS-ADS SYSTEM PROGRAMMING
Audio-4:
Telephone 3: F F F F
To Next Page
Loading...
Need help?
General
