Ferno 24 - Lubricating the Cot

© Ferno-Washington, Inc. / 234-0008-09 / February 2018
19
6.8 Lubricating the Cot
Disinfect and clean the cot before applying lubricant. Use the lubricants
designated below to lubricate the cot. Do not lubricate points marked
with the “do not lubricate” symbol.
LUBRICATION POINTS
1. Undercarriage frame joint SAE 30-weight oil or EZ-1 (1-2 drops)
2. Control handle hinge SAE 30-weight oil or EZ-1 (1-2 drops)
3. I-beam* SAE 30-weight oil or EZ-1 (1-2 drops)
Note: The I-beam runs the length of the cot. To lubricate, tip the stretcher
on end.
LUBRICATIONFREE ITEMS
Wheel bearings (sealed) Do not lubricate
Do Not Lubricate Lubricate
Applying Lubricant
Use a small amount of lubricant (one or two
drops). Lubricate identical points on each
side of the cot. After applying lubricant, wipe
o excess.
NOTICE
Lubricating parts that should not be lubricated allows dirt and
foreign particles to collect on those parts, resulting in damage.
Lubricate only the numbered reference points shown.
Maintenance
1
3
2 2 2