FERREX 700710 - Line Trimmer Operation: Line Feeding

AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
52cc 2 Stroke Brushcutter / Line Trimmer
25
Advancing the line manually
NOTE: Always ensure the engine is turned o before
undertaking this task.
1. Push the bump knob (34) in while pulling on both
lines to manually advance the line. (Fig. AG)
2. Release the bump knob and again pull on both
lines to advance the line further. (Fig. AH)
3. If the line still does not advance remove the spool
and check the lay of the line. It may be twisted or
trapped under over laying line.
Feeding the line
The line trimmer has a bump feed mechanism which
releases the line without having to stop the engine.
1. To release additional line increase the speed of
the motor to no less than half speed, then, lightly
tap the bump knob (34) on the ground while
operating the unit at high speed.
NOTE: Always keep the line fully extended for optimum cutting
performance. Line release becomes more dicult as the cutting line
becomes shorter. Cutting eciency also decreases as the line
becomes shorter.
The line will not extend if the speed of the spool is not operating at least
half speed. If the line does not extend, increase the speed to full speed
while tapping the bump knob on the ground. If the line still does not
extend, stop the motor and check the line inside the spool has not tangled
and also ensure there is sucient line in the spool.
2. Each time the head is bumped it releases approximately 2cm of line.
Release the line until it strikes the cut o knife (32). This may require
several taps.
NOTE: The cut o knife (32) on the clip-on line trimmer guard attachment
(33) will automatically cut o any excess line. For best results tap the head on
AG.
AH.