FERREX 700710 - Preparation: Fuel and Oil

52cc 2 Stroke Brushcutter / Line Trimmer
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. SBC52 • 02/2020 • 700710
(toll free)
30
Operation of the Brushcutter / Line Trimmer
Starting the Brushcutter / Line Trimmer
Choke control
Start position (choke closed)
Run position (choke open)
1. Slide the on/o switch (10) to the ‘ON’ position
(towards the engine) as marked with a “I” below
the switch on the side of the handle housing. (Fig
AL)
2. Move the choke (red lever) (22) (which is located
on the side of the air lter cover (3) housing),
upwards to the full choke or cold start position.
(Fig. AM)
NOTE. This is not required if the engine is already
warm.
3. Push the priming bulb (23)(which is located
under the choke lever) 6-10 times, until the
priming bulb lls with fuel mixture and excess
fuel is pumped down the bypass tube when the
bulb is pressed. (Fig AN)
NOTE. For cold starting this is an important step.
4. Pull the recoil starter (2) lightly until you feel
resistance then pull quickly until the engine
starts. (Fig. AO)
(Under full choke it may only run for 1 or 2
seconds).
5. Push the choke (red lever) (22) half way down
and allow the motor to warm up. Restart if the
motor stops.
Do not pull the cord with a jerk or release it until
fully rewound. Provided the previous steps have
been performed, the motor should start.
As soon as the motor starts and is running, depress
AM.
AN.
AO.
AL.
O -