What to do if my FERREX FM300 Power Tool cannot be switched on?
If your FERREX Power Tool won't switch on, the On/Off switch might be stuck. Try cleaning the On/Off switch. Alternatively, the On/Off switch may be defective.
Why doesn't the tool holder move on my FERREX FM300 after switching it on?
If the tool holder on your FERREX Power Tool doesn't move after you switch it on, it could be due to dirt, wood chips, or other objects located in the gap of the tool holder. Pull the mains cord out of the socket and clean the gap of the tool holder with a vacuum cleaner if necessary.
How to fix oscillation speed if it cannot be increased or decreased on FERREX Power Tool?
If the oscillation speed on your FERREX Power Tool cannot be increased or decreased, the oscillation rate preselector might be dirty. Clean the oscillation rate preselector and the gap with a vacuum cleaner, if necessary.
General| Brand | FERREX |
|---|---|
| Model | FM300 |
| Category | Power Tool |
| Language | English |
Clarifies the meaning of warning, caution, and notice symbols used in the manual.
Defines the intended use of the tool and lists prohibited applications.
Essential safety practices for maintaining a safe work environment.
How to adjust the tool's speed settings for different tasks.
Solutions for issues where the handle or tool cannot be mounted correctly.
Troubleshooting steps for a loose extractor line or dust adapter.
Solutions for problems preventing the multifunction tool from powering on.
To Next Page
