Need help?Do you have a question about the Ferris Evolution Series and is the answer not in the manual?
General| Fuel Type | Gasoline |
|---|---|
| Suspension | Independent Suspension |
| Engine | Kawasaki |
| Transmission | Hydrostatic |
| Speed | 10 mph |
| Deck Material | Fabricated Steel |
General safety advice for operating the machine.
Safety precautions regarding children in the operating area.
Guidelines for safe operation on slopes, including limitations.
Hazard of objects thrown by mower blades and safety precautions.
Hazards associated with moving parts and safety systems.
Hazards related to operating near walls, drop-offs, and water.
Safety warnings about operating in enclosed or poorly ventilated spaces.
Safety precautions for handling fuel and performing maintenance.
General rules for training, preparation, and operation safety.
Warning regarding emissions from the engine as per California law.
Safety notes related to the ignition system of gasoline models.
Safety precautions for handling gasoline and general maintenance.
Explanation and location of safety decals on the mower.
Description of safety interlock systems and operational checks.
Explanation of alert symbols, signal words, and hazard icons.
Location and importance of part and serial numbers for service.
Description of various controls like throttle, choke, and height adjustment.
How to operate levers for forward, reverse, and steering.
Operation of parking brake and ignition switch for starting/stopping.
Essential safety checks and procedures before first-time operation.
Pre-operation checks including fluid levels, fasteners, and fuel.
Step-by-step guide on how to start the engine safely and properly.
Procedures for safely stopping the rider and engine.
Instructions for disengaging drive and moving the rider manually.
Learning to maneuver the zero-turn rider for smooth control.
Practice for forward and reverse travel to master basic maneuvers.
Techniques for turning around corners and in place.
Executing a zero-turn maneuver at the end of a row for efficient mowing.
Steps for engaging PTO, setting height, and starting mowing.
Guidelines for cutting height, grass length, and lawn condition.
Advice on the best time of day and frequency for mowing.
Strategies for cutting strips, changing patterns, and professional cuts.
Explanation of mulching and conditions required for effective mulching.
Guidelines for temporary and long-term storage of the mower.
Steps to prepare and start the mower after extended storage.
A schedule of safety and maintenance tasks based on usage hours.
How to check and maintain proper tire pressure for optimal performance.
Procedures for adding fuel, replacing fuel filter, and inspecting muffler.
Step-by-step instructions for changing engine oil and filter.
Procedures for checking and changing hydraulic oil and filter.
Locations and types of grease and oil points for lubrication.
Removing, inspecting, and discarding mower blades.
How to sharpen and balance mower blades for optimal cutting.
Adjusting seat height and linkage for proper neutral positioning.
Adjusting ground speed control levers for straight tracking.
Adjusting the range selector plates for parking brake system.
Adjusting the compressed length of the parking brake springs.
Adjusting front and operator compartment shock pre-load for ride height.
Adjusting mower deck height and raising for transport.
Adjusting lift rod timing for proper mower deck operation.
Procedure to ensure the mower deck is level for a consistent cut.
Information on deck lift assist springs; not an adjustment point.
Steps for removing, replacing, and installing the PTO drive belt.
Checking and adjusting the PTO drive belt tensioner spring length.
Procedures for replacing the mower deck drive belt.
Steps for removing and installing the hydraulic pump drive belt.
Checking and adjusting the deck drive belt tensioner spring length.
Diagram and explanation of pump drive belt routing.
Identification and amperage of fuses in the machine.
Step-by-step instructions for removing the mower deck from the unit.
Reinstalling the mower deck after servicing.
Procedures for removing the operator compartment assembly.
Reinstalling the operator compartment assembly onto the unit.
Procedures for removing the tank and cleaning battery terminals.
Checking battery voltage, charging, and jump-starting safely.
Overview of common problems, causes, and remedies for the rider.
Further troubleshooting for rider issues like driving and steering.
Common problems with the mower, such as not raising or stalling.
Solutions for streaking, scalping, stepped, uneven cutting, and stingers.
Instructions for using the guide to identify slope angles.
To Next Page