32
www.ferrisindustries.com
Suspension Adjustment
The front shock assemblies (A, Figure 34) and the
operator compartment shock assembly (B) can be
adjusted to vary the amount of pre-load applied to the
springs. This allows the operator to maintain the ride
height.
Use less pre-load for light weight operators. Use
more pre-load for heavy weight operators.
To adjust the spring pre-load:
1. Park the machine on a flat, level surface.
Disengage the PTO, stop the engine and engage
the parking brake.
2. See Figure 34. Using the supplied spanner
wrench (P/N 5022853), insert the tip of the
wrench into the notch in the pre-load adjuster.
While holding the wrench with both hands, turn
CLOCKWISE to decrease the pre-load, turn
COUNTER-CLOCKWISE to increase the pre-load.
Figure 34. Suspension Adjustment
A. Front Shock Assemblies
B. Operator Compartment Shock Assembly
WARNING
Use two hands when adjusting the shock
springs. This will prevent the wrench from
slipping while pressure is being applied.
B
FRONT SHOCK ASSEMBLIES OPERATOR COMPARTMENT SHOCK ASSEMBLY
A
Regular Maintenance
To Next Page
Loading...
Need help?
General
