14 ferrismowers.com
5
A. Part Number: 5106565 - Decal, Main Safety
B. Part Number: 7106109- Decal, Danger
C. Part Number: 5061246- Decal, Pinch Point
D. Part Number: 5102456 - Decal, Fire
E. Part Number: 5061042- Decal, Danger
F. Battery Safety Decal
G. Part Number: 5100536- Decal, Safety, Roll Bar
H. Part Number: 5100685- Decal, Safety, Overhead
Obstacles
I. Part Number: 5100537 - Decal, Warning, Roll Bar
5106565 - Decal, Main Safety
Warning: Read and understand the
Operator’s Manual before using this
unit. Know the location and function
of all controls. Do not operate this
machine unless you are trained.
Warning: Consult technical literature
before performing technical repairs
or maintenance. When leaving the
machine, shutoff engine, set the
parking brake to the lock position,
and remove the ignition key.
Danger - Amputation and
dismemberment hazard: To avoid
injury from rotating blades and
moving parts, keep safety devices
(guards, shields and switches) in
place and working.
Danger - Loss of traction, sliding,
steering and control on slopes
hazard: If machine stops forward
motion, stop the blades, and drive
slowly off the slope.
Danger - Amputation hazard: Do
not mow when children or others are
around. Never carry riders especially
children even with the blades off. Do
not mow in reverse unless absolutely
necessary. Look down and behind –
before and while backing.
Danger - Tipping and slipping
hazard: Operating on slopes can
be hazardous and cause a loss
of control and roll-overs. Do not
operate on slopes over 15* degrees.
Avoid sudden turns or rapid speed
changes. Reduce speed and use
extreme caution on slopes. Avoid
turning down slopes; if possible,
turn up slopes. Do not operate
down slopes towards or near water,
retaining walls, or drop-offs. Give
yourself a minimum of two mower
widths of clearance around these
hazards.
Danger - Thrown objects hazard:
Keep bystanders and children a
safe distance away. Remove objects
that can be thrown by the blade. Do
not mow without discharge chute in
place.
*This limit was determined per International Standard ISO 5395-3:2013,
Section 4.6 and is based on the ISO 5395-3 Stability Test procedure
described in Annex A. The 15 degree “limit of stability” is equal to 60%
of the angle at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating conditions.
7106109 - Decal, Danger, Discharge
To Next Page
Loading...
Need help?
General
