RIMINI DP
A73021552 53
EN
RIMINI DP PROGRAMMABLE DIGITAL ELECTRIC RADIATORS
1. INTRODUCTION
Dear customer:
Thank you for choosing RIMINI DP electric radiators, with their modern design, state-of-the-art
technology, great reliability and great quality construction.
FERROLI RIMINI DP electric radiators and all their materials and components have passed
strict controls to ensure their quality.
Before installing and operating your heater, please read these instructions carefully as they will
ensure the correct working order of the appliance features and for ease of use. Keep them in
case of doubt. Keep them in case of doubt.
2. LOCATION
The radiator should be fitted in the part of the room where the client wants it, depending on the
space available, although preferably on or near outside walls, leaving enough space around the
heater for correct hot air circulation and at least 100 mm, from curtains and furniture, etc. The
distance should be at least 100 mm from the floor.
In bathrooms, the electric heater should be outside the protected area, as indicated (zone 3 of
Figure 1). Keep fitting away from bath and showers.
Areas of the bathroom
3. ELECTRIC CONNECTION
The electric radiator must be connected to the mains supply (230 V ~ 50 Hz) through its plug.
The maximum permissible impedance of the mains at the connection point will be:
Z
max
= 0.16 Ω
In addition, the following warnings must be considered:
- The electric radiator should not be located underneath a light switch where you need
to stretch over the heater to reach or operate the switch.
- The electric line should be protected with a high sensitivity differential device.
ZONE 1
ZONE 2
ZONE 3
To Next Page
Loading...
Need help?
General
