To Next PageTo Next Page
Need help?Do you have a question about the Ferroli Zefiro C11 and is the answer not in the manual?
General| Fuel Type | Natural Gas/LPG |
|---|---|
| Water pressure | 0.2 - 10 bar |
| Ignition | Electronic |
| Heat exchanger material | Copper |
| Mounting | Wall-mounted |
Essential checks before operating the electronic water heater.
Setting the water heater's power level using the adjustment knob.
Adjusting the desired hot water temperature using the selector.
How hot water is delivered and the role of the ionisation probe in flame control.
Automatic shutdown and manual deactivation procedures for the water heater.
Recommendations for preventing scaling and freezing, and environmental care.
Ensuring the chosen location meets requirements for ventilation and safety.
Importance of permanent ventilation and sufficient combustion air supply.
Positioning the unit near taps and flue for optimal performance.
Recommendations for hot water piping, insulation, and diameter.
Connecting gas and water inlets, specifying pipe sizes and cock installation.
Securing the mounting points on the wall for the appliance.
Mounting the water heater onto the wall and tightening fixing screws.
Connecting flexible hot and cold water tubes, checking tightness.
Specifying the required diameter for the flue gas exhaust pipe.
Checking the tightness of the flue gas exhaust system for safe operation.
Advising annual servicing by qualified technicians.
Procedure for removing knobs and casing for maintenance or installation.
Instructions for refitting the casing and knobs after access.
Ensuring compliance with regulations and checking water/gas circuit tightness.
Starting the unit, checking operation, and instructing the user.
Ensuring the correct function of the fume exhaust safety device.
Checking flue gas outlet if the safety device cuts in.
Procedure for replacing the fume thermostat with original parts.
Instructions for cleaning the external casing using mild soap and water.
Recommendation for annual check-ups by the After-Sales Technical Service.
Emphasizing that conversion must be done by qualified personnel.
Steps for replacing burner nozzles and power regulator pin using a kit.
Applying a sticker to indicate the gas type conversion has been completed.
