M
Mary ThompsonAug 26, 2025
What does Error 15 mean on the Ferrotec Controller?
- PPeter WatersAug 27, 2025
Error 15 on the Ferrotec Controller indicates that there is no communication to the master unit.
To Next PageTo Next PageWhat does Error 15 mean on the Ferrotec Controller?
Error 15 on the Ferrotec Controller indicates that there is no communication to the master unit.
What does Error 14 mean on the ferrotec genius Controller?
Error 14 on the Ferrotec Controller means there is no communication to the slave unit.
What does it mean when my ferrotec genius shows Error 06?
If your Ferrotec Controller shows Error 06, it means the voltage undercuts the set point by more than 500 V.
General| Brand | ferrotec |
|---|---|
| Model | genius |
| Category | Controller |
| Language | English |
Specifies the authorized use and limitations of the controller.
Explains different types of safety warnings and symbols.
Defines common safety symbols used in the manual.
Describes the built-in safety mechanisms of the controller.
Explains the function and testing of the emergency stop.
Warns about specific dangers within the operational zone.
Defines operational zones and potential hazard areas.
Step-by-step instructions for safely powering down the unit.
Details on wiring the controller to other system components.
Provides a visual representation of the electrical connections.
Instructions for proper safety grounding.
Specific steps for connecting the controller.
Steps for initial setup, connection, and checks.
Overview of the control panel and its components.
How to use the left joystick for menu selection.
How to use the right joystick to modify values.
Detailed explanation of the LCD screen and its sections.
Procedure for adjusting the emission current.
Adjusting magnet current for beam deflection.
Setting the magnet current's position.
Setting the magnet current's amplitude.
Basic principles of menu navigation.
How to set and adjust evaporation parameters.
Adjusting the magnet current's beam position.
Defining the operational limits for magnet current.
Adjusting the magnet current's beam amplitude.
Adjusting the high voltage output level.
Setting the maximum allowable emission current.
Setting the frequency of magnet current deflection.
Accessing and using service functions.
Explanation and handling of system error messages.
Explanation and handling of system warnings.
Pinout and configuration for the X110 I/O interface.
Control logic for the High Voltage power supply.
Configuration options for different sweep modes.
Utilizing dwell matrix patterns for energy distribution.