Need help?Do you have a question about the Festo CPV10-VI and is the answer not in the manual?
Instructions for mounting the CPV valve terminal using individual tubing.
Instructions for mounting the CPV valve terminal onto a pneumatic multipin.
Instructions for preparing the compressed air supply for the valve terminal.
Connecting compressed air and exhaust tubing to the valve terminal.
Instructions for connecting electrical cables to the valve terminal.
Methods for testing the functionality of the valves.
Guidance on identifying and resolving functional impairments.
Instructions for mounting the CPV valve terminal using individual tubing.
Instructions for mounting the CPV valve terminal onto a pneumatic multipin.
Instructions for preparing the compressed air supply for the valve terminal.
Connecting compressed air and exhaust tubing to the valve terminal.
Instructions for connecting electrical cables to the valve terminal.
Methods for testing the functionality of the valves.
Guidance on identifying and resolving functional impairments.
General| Input signal voltage | 24 V DC |
|---|---|
| Output voltage | 24 V DC |
| Max. output current per module | 2 A |
| Nominal tightening torque | 0.5 Nm |
| Degree of protection | IP65 |
| Short circuit strength | Yes |
| Reverse polarity protection | Yes |
| Output current | ≤ 0.5 A |
| Ambient temperature | 0 ... 50 °C |
| Storage temperature | -20 ... 70 °C |
| Ambient temperature range | 0 ... 50 °C |
| Storage temperature range | -20 ... 70 °C |
To Next Page
