Festo KBS-FEC FC30- 0206NH English32
8. If you are using the Multiprog software:
8.1. Create a new project using the template for the
IPC FEC FC30.
8.2. Save the project under a meaningful name.
8.3. Download the project to the controller (does not
have to be programmed). If you are not using
COM1 on your programming PC, then you must
firstswitchtotheCOMportthatyouareusing.
8.4. Start the controller. If you now apply a signal at
the input, the output with the same address must
switch to “1“.
All further information can be found in the manual for the
I PC F EC Compact (P.BE-FEC-C-SYS ....) or on the product
CD (part no. 189530).
To Next Page
Loading...
