Festool CT 26 E HEPA - Page 14

14
ing the filter bag).
 Replace the top section [2-1] and close the
locking clips [2-2] .
Changing the disposal bag
Inserting the disposal bag [7]
 Open the locking clips [2-2] and remove the top
section of the machine [2-1] .
 Insert a new disposal bag (ENS-CT26/36/48) on
the inlet nozzle of the container and lock in po-
sition.
Important: The lateral openings on the disposal
bag must be positioned inside the container.
Make sure that the bolt engages.
 Place the disposal bag over the edge of the con-
tainer.
Make sure that the contacts [7-1] are free.
 Replace the top section [2-1] and close the
locking clips [2-2] .
Removing the disposal bag [8]
 Open the locking clips [2-2] and remove the top
section of the machine
[2-1] .
 Close the disposal bag.
 Remove the disposal bag.
 Dispose of the used disposal bag in accordance
with statutory regulations.
 Clean the dust container [2-3] .
 Replace the top section [2-1] and close the
locking clips [2-2] .
Changing the main filter
 Open the locking clips [2-2] and remove the top
section of the machine [2-1] .
 Turn the top section of the machine so that the
main filter is facing upwards (Fig. [9] ).
6
1
2
3
1
2
3
7
ENS-CT 26/36/48
7-1
NOTE
Motor damage
 Never operate the extractor without a main filter
fitted as the motor may become damaged.
1
2
3
8