Festool Domino XL DF 700 EQ - Page 10

13
Removing the tool X Lift the unlocking device [7-2] until it audibly
disengages using the open-ended spanner [7-
3] supplied (SW 12).
X Separate the motor unit [7-5] from the guide
frame [7-4] .
X Press and hold the spindle lock [8-1] .
X Loosen the cutter [8-3] using the open-ended
spanner [8-2] and remove.
X Release the spindle lock [8-1] .
Inserting the tool
X Press and hold the spindle lock [8-1] .
X Use the open-ended spanner [8-2] to screw on
the cutter [8-3] .
X Release the spindle lock [8-1] .
X Slide the guide frame [7-4] onto the motor unit
[7-5] until it audibly engages.
7
7-3
7-6
7-2
7-1
7-5
7-6
7-4
WARNING
Risk of injury
X Before inserting a new cutter ensure that the
machine, the guide frame and the guides
[7-1]
and [7-6] are clean.
X Remove any contamination that may be present.
X Only use sharp, undamaged and clean tools.
8-2
8-3
8
8-1