14
Setting stop pins
The stop pins on the front of the fence are used to
register the tool against the edge of the workpiece.
This provides rapid and precise placement of the
tool on the workpiece.
Six stop pins
[9-2]
are available on the stop side of
the DOMINO joining machine.
Stop pins that are not required can be individually
engaged by exerting overpressure and released us-
ing the button
[9-1]
.
These serve as spacers to the cutter centre and can
be inserted at different locations - see image
[9]
:
Widening the contact surface
The contact surface widening device
[10-1]
can be
used to enlarge the contact surface when routing
on the workpiece edge, thus allowing safer guid-
ance of the machine.
X
Secure the contact surface widening device us-
ing the two screws
[10-2]
on the threaded holes
[10-3]
of the guide frame.
The contact surfaces of the contact surface wid-
ening device
[10-5]
and the table
[10-4]
must
be level.
Operation
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
–Always secure the workpiece in such a manner
that it cannot move while being processed.
–Always hold the machine with two hands on the
handles
[1-3]
when performing work. This re-
duces the risk of injury and is a prerequisite for
precise work.
AThree possible spacings to a supply side (1 -
2 - 3)
BTwo dowel holes beside each other from a
supply side (1 - 3)
CTwo dowel holes by changing the workpiece,
e.g. for cross-section cut.
To Next Page
Loading...
