5
TO REDUCE THE RISK OF
INJURY, USER MUST READ INSTRUC-
TION MANUAL.
Technical data
Power 720 W
Speed (no load) 15 600 rpm
Plane width 65 mm (2.56'')
Chip thickness 0 - 4 mm (0’’ - 0.16'')
Max. rebate depth 23 mm (0.90'')
Weight (excluding cable) 2.4 kg (5.3 lbs)
Degree of protection
/ II
Symbols
V Volts
A Amperes
Hz Hertz
~ Alternating current
n
0
No load speed
Class II Construction
rpm Revolutions or reciprocation per min-
ute
Ø Diameter
Warning of general danger
Read the Operating Instructions/
Notes!
Intended use
The tool together with the available Festool
accessories is designed for processing wood,
soft plastics and similar materials.
The user is liable for damage
and injury resulting from incorrect usage!
Power supply
and start-up
The network voltage must
conform to the voltage indicated on the rat-
ing plate. A 16 A safety fuse (for 120 V) or
a corresponding protective circuit-breaker
is required.
To switch on, fi rst press the switch lock (1.2)
and then the switch (1.1) (press = ON, re-
lease = OFF).
Extension cable
If an extension cable is required, it must
have a sufficient cross-section so as to
prevent an excessive drop in voltage or
overheating. An excessive drop in voltage
reduces the output and can lead to failure of
the motor. The table beside shows you the
correct cable diameter as a function of the
cable length for the planer EHL 65 E. Use
only U.L. and CSA listed extension cables.
1.21.1
Total Extension Cord
Lenght (feed)
25 50 100 150
Cord size (AWG) 18 16 12 10
To Next Page
Loading...
