12
Attaching sanding accessories using Stick-
Fix [4]
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.
In the case of a weakening adhesive effect of
the StickFix surface, the sanding pad acces-
sories, in particular those which are not yet touch-
ing the workpiece,
may come loose from the sand-
ing pad and cause injuries
. Replace the sanding
pad!
Dust extraction
The power tool does not have its own extractor unit.
At the extractor connector
[1-5]
, a Festool mobile
dust extractor with an extraction hose diameter of
27 mm should be connected.
Recommendation:
Use anti-static extractor hose!
This helps reduce the electric charge.
Working with the machine
Observe the following instructions:
– Do not overload the machine by pressing with ex-
cessive force! The best sanding results are
achieved with moderate application pressure.
The sanding capacity and quality are mainly de-
pendent on the selection of the correct abrasive.
– Hold the machine with one hand on the handle
[1-7]
.
For sanding we recommend the following settings
for the adjusting wheel
[1-2]
:
WARNING
Dust hazard
Dust can be hazardous to health. Always work
with a dust extractor.
Always read applicable national regulations be-
fore extracting hazardous dust.
WARNING
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.
Sanding work Adjusting
wheel set-
ting
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered surface prior
to paintwork
– Intermediate sanding of paintwork on sur-
faces
5 - 6
– Sanding thinly applied undercoat
– Sanding wood with nonwoven pad
– Edge breaking on wooden parts
– Smoothing primed wooden surfaces
4 - 5
To Next Page
Loading...
