If the power tool is used in cordless op
eration with a mobile dust extractor, the
battery life decreases. Reducing the
suction power minimises this effect.
High suction power can impair control of
the power tool. Reducing the suction
power minimises this effect.
Recommendation: Use an antistatic suction
hose. This helps reduce the electric charge.
7.5 Edge protector [6]
The edge protector [1-8] reduces contact of the
sanding pad circumference with a surface (e.g.
when sanding along a wall or a window), thus
preventing back-kick of the machine, or ma
chine damage.
Push the edge protector into the groove on
the machine.
Slot the two ends of the edge protector into
place until they click.
Loosen both ends of the edge protector.
Remove the edge protector by pulling it for
wards.
8 Working with the machine
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
Observe the following instructions:
– Do not overload the machine by pressing
with excessive force! The best sanding re
sults are achieved with moderate applica
tion pressure. The sanding capacity and
quality are mainly dependent on the selec
tion of the correct abrasive.
– Hold the machine with one hand on the
handle [1-9].
8.1 Warning signal
The machine shuts down and makes a sound:
► Switch off the machine.
Battery pack is empty.
► Change the battery pack.
The machine shuts down and does not make a
sound:
Machine is overheated or has been overloaded.
► Switch off the machine for 30 seconds.
► Reduce the machine load.
If the machine's final speed is then not reached,
allow the machine to cool down.
9 Service and maintenance
WARNING
Risk of injury, electric shock
► When carrying out servicing and mainte
nance work, always remove the batteries
or the mains adapter from the power tool
first.
► All maintenance and repair work which re
quires the motor housing to be opened
should always be carried out by an author
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
spare parts. Order no. at:
www.festool.co.uk/service
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of any obstruction.
In the event of a slowdown in performance or
increased vibrations, blow and clean cooling air
openings.
► Keep the contacts on the machine, charger
and battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note en
closed instructions of the battery pack!
10 Accessories
Use only original Festool sanding pads. Low-
quality sanding and polishing pads may cause
serious machine imbalances that decrease the
quality of the work results and increase wear
on the power tool.
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
11 Environment
Do not dispose of electric power tools in
household waste! recycle devices, accessories
English
20
To Next Page
Loading...
Need help?
General