To Next PageTo Next Page
Need help?Do you have a question about the Festool KAPEX KS 120 REB and is the answer not in the manual?
General| Blade bore | 30 mm |
|---|---|
| Blade diameter | 260 mm |
| Saw blade included | Yes |
| Input power | 1600 W |
| Power source | AC |
| Idle speed (max) | 3400 RPM |
| Idle speed (min) | 1400 RPM |
| Cutting depth (90º) | 305 mm |
| Bevel type | Double bevel |
| Sliding rails | - |
Weight and Dimensions| Depth | 500 mm |
|---|---|
| Width | 713 mm |
| Height | 470 mm |
| Weight | 23100 g |
General safety warnings applicable to all power tools.
Safety instructions specific to the mitre saw machine's operation.
Additional safety guidelines and precautions for using the power tool.
Specific safety measures required when sawing aluminium.
Precautions and warnings related to the laser guide.
Identification of potential risks during machine operation.
Declared noise emission values and relevant standards.
Warning regarding incorrect voltage and frequency for the machine.
Essential steps and checks before the first use of the machine.
Instructions for correctly turning the machine on and off.
Guidance on mounting and securing the machine to a work surface.
Procedures for safely securing and transporting the machine.
Guidance on choosing the correct saw blade for specific materials.
Instructions for changing saw blades and other tools.
Step-by-step instructions for installing a saw blade correctly.
How to fit and properly use the workpiece clamp.
Information on the importance and setup of dust extraction.
How to extend the table for supporting larger workpieces.
Adjusting and using the stop ruler for precise cuts.
Setting the horizontal angle for mitre cuts.
Setting the vertical angle for bevel cuts.
Utilizing the machine's special position for specific tasks.
How to set the cutting depth for grooving or facing.
Locking the saw unit in a fixed position along the guide rods.
Operating and checking the integrated laser guide.
Safety precautions regarding flying debris and workpiece parts.
Recommended posture and hand placement during operation.
Maximum dimensions for workpieces with and without accessories.
Maintaining cleanliness around the saw blade area.
Proper methods and safety checks for securing workpieces.
Adjusting the cutting speed for different materials.
How to perform cuts without using the saw's pull movement.
How to perform cuts utilizing the saw's pull movement.
Using the bevel function for angle bisection and measurements.
Information on obtaining authorized service and repairs.
Procedure for calibrating and adjusting the laser guide.
Adjusting the indicator for horizontal mitre angles.
Adjusting the indicator for vertical mitre angles.
Instructions for replacing the table top insert.
Maintaining the laser window for clarity and function.
