13
Sanding close to edges
The detachable brush segment allows you to re-
duce the distance between the wall/ceiling and
the side of the sanding pad.
Press and hold the knob [7-1]. f
Remove the brush segment [7-2]. f
There is a retainer in the lid of the SYSTAINER L
for storing the brush segment.
Hook in the brush segment at the opposite end f
to the knob [7-1], swivel towards the sanding
head and engage into position.
Dust extraction
CAUTION
Breathing in dust can damage the respiratory
passage!
Always connect the machine to a dust extrac- f
tor.
When performing work that generates dust, f
always wear a dust mask.
A Festool dust extractor with an extractor hose
diameter of 27 mm or 36 mm (recommended due
to the improved suction power) can be connected
to the extractor connector [8-2].
The special extraction hose and special suction L
sleeve [8-1] (available as an accessory) ensure
permanent attachment and protect against
kinking.
Use the dust extractor CT 36 E AC-LHS on large L
surfaces because this extractor guarantees the
permanent suction power required.
Press the green button [8-4] to open the me- f
chanical lock [8-3].
Attach the extraction hose on the dust extractor f
to the outlet spigot [8-2].
Swivel the mechanical lock [8-3] upwards until f
it engages.
Operation
WARNING
Risk of injury
Do not hold the machine by the head. f
Hold the machine with both hands. f
Make sure that all clamping levers are closed f
before operating the machine.
7
7-1
7-2
1
2
8
8-1
8-2
8-4
8-3
1
2
To Next Page
Loading...
