19
CS 50 EB
- A worn or damaged bench insert is to be re-
placed
- The slider [11-1] can be used to open the hatch
[11-3] to enable removal of cutting residues
from the lower protective cover. In order to re-
move larger deposits, the hatch can be opened
completely by removing the screw [11-2]. Prior
to commissioning, the hatch must be closed
again!
- On completion of your work, wind the power
cable around the holders [2-1].
- A damper means that the saw unit runs back
evenly across the entire drawing length. If this
is not the case, the damper can be adjusted
through the hole [2-5].
10 Accessories, tools
Festool offers a comprehensive range of acces-
sories that ensures versatile and effective deploy-
ment of your machine, e.g. table widening, table
lengthening, sliding table, mitre guide, transport
rollers, extraction set.
In order to be able to saw different materials
quickly and cleanly, Festool offers saw blades that
are specially designed for your machine.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
”www.festool.com”.
11 Disposal
Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible re-
cycling centre. Observe the valid national regula-
tions.
To Next Page
Loading...
