This power tool is compatible with commercially available tools with 1/4″ hex shank, as per DIN 3126 type E 6.3. [5]
Warning : CENTROTEC accessories are not compatible with this power tool.
Changing tools [3]
Pull the sleeve of the bit locking system forward to release the insertion tool.
Remove insertion tool.
Push the new insertion tool into the locking sleeve until it audibly clicks into place.
Changing the bit in the insertion tool [3]
Remove the bit from the insertion tool.
Insert a new bit into the insertion tool.
Working with the machine
WARNING
Risk of injury
Only attach the power tool to the screw when it is switched off.
Always secure the work piece in such a manner that it cannot move.
Keep hands away from the rotating insertion tools.
CAUTION
Risk of burns
Tool holder and tools can become very hot during operation!
Wear protective gloves when changing the tools!
Allow to cool before attaching to belt clip.
Bit store [1-9]
WARNING
Risk of injury from metal cuttings in the bit store.
Clean the bit store regularly and clear out metal cuttings.
Magnetic, to pick up bits.
Acoustic warning signal
Acoustic warning signals sound and the tool switches off in the following operating states:
Battery empty/incompatible or tool overloaded.
Charge/change the battery.
Reduce the load on the tool.
When pressing the on/off switch. Tool has overheated.
Once it has cooled down, restart the tool.
Tool is faulty.
Contact the manufacturer to rectify the fault.
To Next Page
Loading...
Need help?
General
