24
TS 55 R
XAdjust the guide play between the saw table
and the guide rail using the two adjustable
jaws [9-1].
Bed in the splinterguard [9-3] before using the
guide rail for the first time:
XSet the machine speed to 6.
XPlace the machine at the rear end of the guide
rail together with the complete guide plate.
XSwitch on the machine.
XPush down the machine slowly to the max.
preset cutting depth and cut along the full
length of the splinterguard without stopping.
The edge of the splinterguard now corresponds
exactly to the cutting edge.
11 Environment
Do not throw the power tool in your
household waste! Dispose of the
machine, accessories and packaging
at an environmentally-responsible
recycling centre! Observe the valid
national regulations.
경기도 의왕시 맑은내길 67, 501-2호
(오전동, 에이엘티지식산업센터)
(우) 16071
전화: 02-6022-6740
팩스: 02-6022-6799
http://www.festool.co.kr
Gyeonggi-do, Uiwang-si Clear No. 67, 501-2
(AM East, ADT Knowledge Industrial Center)
(R) 16071
phone: 02-6022-6740
fax: 02-6022-6799
http://www.festool.co.kr
To Previous Page
Loading...
