Please note:
The machine can only be op
erated under the following conditions [2C]:
Both battery packs are used. Maximum power
with two battery packs (36 V).
Only the lower battery pack is used. Less power
with one battery pack (18 V).
7.1 Capacity display
The capacity display [1-13]
indicates the charge
of the battery pack for approx. 2 seconds after
the button
[1-11] is pressed:
70‑100%
40‑70%
15‑40%
< 15%
*
*
Recommendation:
Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8 Settings
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
8.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-12] (see "Technical data"). This ena
bles you to optimise the cutting speed to suit
each surface.
Speed range per material
Solid wood (hard, soft) 6
Chipboard and hardboard 3–6
Laminated wood, blockboard, veneered
and laminated panels
6
Laminate, mineral materials 4–6
Plaster- and cement-bonded chipboard
and fibreboard
1–3
Aluminium panels and profiles up to
15 mm
4–6
Plastics, fibre-reinforced plastics, paper
and fabric
3–5
Acrylic glass 4–5
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re
moved.
English
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
