Fetco HWB-5 - User Manual

Questions and Answers

J
justin51Aug 12, 2025
Why is the ready light not on for my Fetco HWB-5 Water Dispenser?
- M
  Manuel SummersAug 12, 2025
  There are several reasons why the ready light might not be on. First, the dispenser may not be up to the set temperature yet; wait at least 30 minutes after turning it on. Second, the internal circuit breaker might have tripped; turn the power switch off and then back on to reset it. Finally, there may be no power to the dispenser; reset the circuit breaker on the wall by turning it off and then on.
D
Daniel ParkerAug 19, 2025
What to do if my Fetco Water Dispenser is not hot enough?
- J
  james95Aug 19, 2025
  If your Fetco Water Dispenser isn't hot enough, it could be due to a couple of reasons. You might be using water faster than the dispenser can heat it, so ensure the ready light is on before drawing water; consider a larger dispenser if the problem persists. Alternatively, the thermostat might be set too low; adjust it according to the user's guide.
J
jacqueline05Aug 27, 2025
How to fix a sight gauge leak on a Fetco Water Dispenser?
- D
  Desiree SimmonsAug 27, 2025
  If the sight gauge on your Fetco Water Dispenser is leaking, it could be due to a loose cap. Try tightening the chrome cap on top of the gauge. If that doesn't solve the problem, the gauge tube or gasket might be broken. Turn off the sight gauge valve (ON = posts up and down, OFF = posts front to back), then tighten or replace the necessary parts and reopen the valve.
H
hebertarthurSep 3, 2025
What to do if the Fetco Water Dispenser faucet drips?
- B
  Benjamin SimsSep 3, 2025
  If the faucet of your Fetco Water Dispenser is dripping, it is likely due to a worn seat cup or a broken faucet spring. To fix this, turn off the power to the dispenser and drain the water from the faucet until it stops. Once the water stops, carefully remove the upper assembly and replace the worn parts.