EasyManua.ls Logo

Fiamma F1 User Manual

Fiamma F1
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
58
1.
- Le bandeau frontal ne ferme pas bien du côté opposé
au treuil.
- Lead bar not closing on the side opposite the winch
- Die Frontblende schließt auf der linken Seite nicht
100%ig.
- Il frontale della veranda non chiude dal lato opposto
dell’arganello.
2.
- Ouvrir le bandeau frontal du store et enlever l'embout
en desserrant l'ecrou avec une clef de 13 mm.
- Open the lead bar and using a 13mm wrench loosen
the bolt and remove the lead bar cap.
- Die Markise herauskurbeln, die Mutter mit dem 13er
Schlüssel lösen und die Abdeckung der Frontblende
mit dem Stützfuß herausziehen.
- Aprire il frontale della veranda e rimuovere la spalletta
del frontale allentando il dado mediante una chiave
da 13 mm.
- Lead bar not closing on the side opposite the winch.
- Die Frontblende schließt auf der linken Seite nicht ordnungsgemäß
- Le bandeau frontal ne ferme pas bien du côté opposé au treuil
- Il frontale della veranda non chiude dal lato opposto dell’arganello.
3.
- Enlever la vis 4x50 mm et la remplacer par une vis
4x70 mm (livrable sur demande Réf. 92114-490) et
visser afin de tendre la toile.
- Remove the 4x50mm screw, and replace it with a
4x70mm screw (available upon request Item No.
92114-490), tighten the screw to pull the fabric taut
- Die vorhandene Schraube 4x50mm durch eine
längere 4x70 mm Schraube ersetzen ( auf Anfrage
lieferbar Art. Nr. 92114-490), dann fester anziehen,
um das Tuch zu spannen.
- Togliere la vite 4x50 mm e sostituirla con una da
4x70 mm (fornibile su richiesta Codice 92114-490) ed
avvitare per tendere il telo.
FIAMMA S.p.A 56 S. Rocco, 21010 Cardano - Italy
+(39) 0331709111 Fax +(39) 0331263777 www.fiamma.com
Fiamma Technical Service
e-mail: service@fiamma.it
F1 - F1L - F45 PLUS - F45 PLUS L - F50 ZIP - F50 PRO - F55 PRO - F60 TOP - F65 TOP
10/2001
TS-01 - 01
®
®
Markisen Reparaturanleitung - Awning Repair Instructions
Réparation du store - Riparazioni delle Verande
Question and Answer IconNeed help?

Do you have a question about the Fiamma F1 and is the answer not in the manual?

Fiamma F1 Specifications

General IconGeneral
BrandFiamma
ModelF1
CategoryAccessories
LanguageEnglish

Summary

Awning Lead Bar Closing Repair Instructions

Diagnose Lead Bar Not Closing Issue

Identify the problem where the lead bar does not close properly on the side opposite the winch.

Remove Lead Bar Cap and Bolt

Loosen the bolt with a 13mm wrench and remove the lead bar cap.

Replace Screw for Fabric Tension

Replace the 4x50mm screw with a 4x70mm screw to tighten the fabric.

Verify Lead Bar Closure

Confirm the correct closing of the lead bar after performing the repair steps.

Apply Adhesive Tape to Roller Tube

Add adhesive tape layers to the roller tube to increase its diameter and ensure closure.

Related product manuals