KNOWING YOUR CAR
42
Emergency manoeuvre
If the switches fail, the soft top can be
moved manually proceeding as
described below:
❒ take the key provided and located in
the boot together with the tool box
or the Fix&Go kit;
❒ fit the wrench in the special housing
A-fig. 37 inside the luggage
compartment, under the parcel
shelf;
❒ turn in clockwise direction to open
the soft top and counter-clockwise
to close it.
37
DVDF0S176c
Initialisation procedure
The soft top must be re-initialised after
disconnecting the battery or if the
relevant protection fuse is blown.
Proceed as follows:
❒ before carrying out any other
operation, make sure the engine is
on during the whole initialisation
procedure;
❒ keep the opening button A-fig. 34
pressed until the soft top is
completely open;
❒ when the soft top is completely
open, keep the button pressed for
at least 2 seconds;
❒ keep the closing button B-fig. 34
pressed until the soft top is
completely closed;
❒ when the soft top is completely
closed, keep the button B-fig. 34
pressed for at least 2 seconds.
When the procedure is terminated, the
soft top will automatically carry out a
complete opening and closing cycle
(up to 25 cm from the completely
closed position) to inform the driver
that correct operation has been
restored.
Important notes
❒ The horizontal and vertical parts of
the soft top can be operated at any
speed lower than 100 and 80 km/h
respectively.
❒ The top can be operated at any
temperature in the range from
-18 to +80°C.
❒ It is recommended to have the
engine running always when
opening or closing the soft top.
❒ If required, remove the battery with
open or closed soft top, but NOT
when the soft top is moving.
❒ Do not fix a roof rack to the top and
do not travel with objects resting on
the open top.
To Next Page
Loading...
