KNOWING YOUR CAR
38
With the windscreen wiper on and
reverse gear engaged, rear window
wiping will be continuous in the same
way.
“Smart washing” function
❒ Push the lever towards the
dashboard and hold it in position to
activate the rear window washer jet.
RAIN SENSOR
(for versions/markets, where provided)
4)
The sensor will be activated when the
ignition device is turned to MAR, and
will be deactivated in the STOP
position.
29
DVDF0S0217c
This is a device located behind the
interior rear view mirror fig. 30, in
contact with the windscreen. It can
measure the amount of rain and,
consequently, control the automatic
windscreen wiping mode depending
on the amount of water on the
windscreen.
IMPORTANT Keep the window clean in
the sensor area.
AUTOMATIC WIPING
(for versions/markets, where provided)
Activation
The user can choose automatic wiping
by moving the right steering wheel
stalk fig. 28 to the AUTO (B) position.
The activation of the automatic wiping
will be notified to the driver by a single
stroke.
30
DVDF0S0215c
Sensitivity Adjustment
The rain sensor sensitivity can be
adjusted through the display menu or
on the UconnectTM 5" or 7” system.
Inhibition
If the starter switch is moved to the
STOP position, leaving the right
steering wheel stalk in the AUTO (B)
position, when the vehicle is next
started (starter switch in the MAR
position), no wiping cycle to prevent
damage to the system if the
windscreen is being washed manually
or if there is ice on it.
To re-enable the automatic wiping
mode:
❒ Put the right steering wheel stalk in
a position other than AUTO and
then back to the AUTO position;
❒ exceed the speed of 5 km/h when
the sensor detects rain.
Deactivation
The user can disable automatic wiping
by moving the right steering wheel
stalk to a position other than AUTO.
To Next Page
Loading...
