Lock Or Unlock The Liftgate
To Lock The Liftgate
With a valid Passive Entry RKE transmitter
within 5 ft (1.5 m) of the liftgate, push
Passive Entry LOCK button located to the
right of Passive Entry liftgate unlock/release
button.
To Unlock/Enter The Liftgate
The liftgate passive entry unlock feature is
built into the electronic liftgate handle.
With a valid passive entry RKE transmitter
within 5 ft (1.5 m) of the liftgate, push the
Passive Entry liftgate unlock/release button
(2) and pull to open the liftgate.
NOTE:
Refer to “Doors” in “Getting To Know Your
Vehicle” in your Owner's Manual on the
DVD for further information.
ENGINE STARTING/STOPPING
Starting
1. With a valid Keyless Enter-N-Go Key
Fob inside the vehicle.
2. Place the shift lever in PARK or
NEUTRAL.
3.
While pushing the brake pedal, push the
ENGINE START/STOP button once. If
the engine fails to s tart, the starter will
disengage automatically after 10 seconds.
4. To stop the cranking of the engine prior
to the engine starting, push the button
again.
NOTE:
In case the ignition switch does not change
with the push of a button, the RKE transmitter (Key Fob) may have a low or dead bat-
tery. In this situation, a back up method can be used to operate the ignition switch. Put
the nose side of the Key Fob against the ENGINE START/STOP button and push to op-
erate t he ignition switch.
Passive Entry Release Button
Passive Entry Liftgate Release Button
Engine Start/Stop Button
GETTING STARTED
14
To Next Page
