Left Lane Departure — Both Lanes Detected
• When the LaneSense system is ON, the lane lines turn from gray to white to indicate
that both of the lane markings have been detected. The LaneSense indicator is solid
green when both lane markings have been detected and the system is “armed” to pro-
vide visual warnings in the EVIC and a torque warning in the steering wheel if an unin-
tentional lane departure occurs.
• When the LaneSense system senses a lane drift situation, the left thick lane line and
left thin line turn solid yellow. The LaneSense indicator changes from solid green to
solid yellow. At this time torque is applied to the steering wheel in the opposite direc-
tion of the lane boundary.
For example: If approaching the left side of the lane the steering wheel will turn to the
right.
• When the LaneSense system senses the lane has been approached and is in a lane
departure situation, the left thick lane line flashes yellow (on/off) and the left thin line
remains solid yellow. The LaneSense indicator changes from solid yellow to flashing yel-
low. At this time torque is applied to the steering wheel in the opposite direction of
the lane boundary.
For example: If approaching the left side of the lane the steering wheel will turn to the
right.
NOTE:
The LaneSense sys tem operates with the similar behavior for a right lane departure.
Changing LaneSense Status
The LaneSense sys tem has settings to adjust the intensity of the torque warning and the
warning zone sensitivity (early/late) that you can configure through the Uconnect system
screen.
NOTE:
• When enabled the system operates above 37 mph (60 km/h) and below 112 mph
(180 km/h).
• Use of the turn signal suppresses the warnings.
• The system will not apply torque to the steering wheel whenever a safety system en-
gages. (anti-lock brakes, traction control system, electronic stability control, forward col-
lision warning, etc.).
OPERATING YOUR VEHICLE
61
To Next Page
Loading...
