Fiat 500x - Fix&Go Kit

IN AN EMERGENCY
160
FIX&GO KIT
(where provided)
158) 159)
75)
DESCRIPTION
The Fix&Go quick tyre repair kit
fig. 147 is located in the boot, inside a
dedicated container and consists of:
one cartridge (1) containing sealant
and fitted with: transparent tube for
injecting the sealant (4) and sticker (3)
with the wording "Max. 80 km/h" to be
placed in a clearly visible position (e.g.
on the dashboard) after repairing the
tyre;
one compressor (2);
a pair of gloves located in the hose
compartment of the cartridge (4).
147 P2000158
REPAIR PROCEDURE
Proceed as follows:
stop the car in a position that is not
dangerous for oncoming traffic where
you can carry out the procedure safely.
The ground must be flat and sufficiently
compact;
stop the engine, engage the hazard
warning lights and the parking brake;
before getting out of the vehicle,
put on the reflective safety jacket (if
required by the regulations in force); In
any case, follow the road safety laws
in force in the country where you are
driving;
insert the sealant cartridge (1)
into the corresponding compressor
compartment (2)and press it down
hard fig. 147. Remove the speed limit
sticker (3)and apply it in a clearly visible
position fig. 148;
148 P2000162
wear the gloves;
remove the cap from the tyre valve
and connect and screw the transparent
tube of the sealing fluid (4) fig. 147
onto the valve. If a 250 ml cartridge is
present the housing of the transparent
tube is provided with removable ring to
facilitate extraction. Make sure that the
ON-OFF button (5) fig. 149 is in the off
position (button not pressed);
149 P2000160
insert the electrical connector (3)
fig. 150 into the 12V socket on the car
and start the engine;