GETTING TO KNOW YOUR CAR
22
it in this position moving the lever (A)
again in position (2).
WARNING
16)
All adjustments must be carried out
only with the car stationary and engine
stopped.
17)
It is absolutely forbidden to carry
out any after-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft device) that could badly affect
performance and safety, invalidate
the warranty and also result in non-
compliance of the car with type-approval
requirements.
REAR-VIEW
MIRRORS
INTERIOR MIRROR
Manual adjustment: Operate lever
(A) fig. 24 to adjust the mirror into two
different positions: normal or anti-glare.
The mirror is fitted with a safety device
that causes its release in the event of a
violent impact with the passenger.
24 F1B0033C
Electrochromic mirror
An automatic anti-glare device is fitted
on some versions, which automatically
modifies its reflecting properties to
prevent dazzling the driver fig. 25.
The electrochromic mirror has an
ON/OFF button to activate/deactivate
the electrochromic anti-glare function.
25 F1B0034C
When reverse is engaged, the mirror is
automatically set for daytime use.
DOOR MIRRORS
Electric adjustment
18)
Adjusting the mirrors is possible with
the ignition device at MAR and for
about 3 minutes after the ignition
device switches to STOP (or also
after the mechanical key has been
extracted, for cars equipped with
mechanical key with remote control).
When one of the front doors is opened
this operation is disabled.
Select the desired mirror using device
(A) fig. 26:
position 1: left mirror selected;
position 2: right mirror selected;
26 F1B0035C
To adjust the selected mirror, press
button (B) in the four directions shown
by the arrows.
IMPORTANT Once adjustment is
complete, rotate device (A) to position
(0) to prevent accidental movements.
To Next Page
Loading...
