The following table has the same information as the previous diagram to show how to respect current laws.
5-seater combi versions
Child restraint systems The child's weight
Front passenger seat
(1) (2)
Rear side seat Rear central seat
Central cot Group 0 < to 10 kg X
U (3)
U (3)
U (3)
Child restraint seat
facing backwards
Groups 0 and 0+
<to13kg U U(4) U(4)
Child restraint seat
facing backwards
Groups 0 and 1+
<to13kgandfrom9to
18 kg
U U (4) U (4)
Child seat facing
forward Group 1
from9to18kg X U(5) U(5)
Booster seat Groups
2 and 3
from 15 to 25 kg and
from 22 to 36 kg
X U (5) U (5)
X: seat not authorised to install a child restraint of this type.
U: seat allowing fastening with seat belt for an approved child seat like "Universal"; check possible installation.
(2): position the vehicle's seat as far back and as high as possible, then slightly incline the backrest (about 25°).
(3): the cot is installed crosswise with respect to the vehicle and takes up at least two seats. The child's head must be opposite
the vehicle's door.
(4): move the front seat as far forward as possible to install the child seat backwards from driving direction, then move it back
to maximum so it does not come into contact with the child seat.
(5): child seat facing forward: position the child seat backrest in contact with the seat backrest. In any case, remove the rear
seat headrest that the child seat is positioned against. This should be done before positioning the child seat (please see the
paragraph "Rear headrest" in chapter "Knowing your vehicle"). Do not move the seat in front of the child back more than half
the distance and do not incline it more than 25°.
108
SAFETY
To Next Page
Loading...
