FIBARO Smoke Sensor - Page 19

Installation and Operation Guide
Smoke Sensor Page | 19
To reset the Smoke Sensor follow these instructions:
1. Make sure the device is connected to the power supply.
2. Press and hold the B-button for 3 seconds. The LED will glow white.
3. A short signal will sound.
4. Release the B-button.
5. Wait until the LED turns yellow, you are entering the reset menu.
6. Press the B - button briefly to confirm the menu.
A successful reset will be confirmed by the LED changing color to red and going
out. At the same time, a short beep will sound.
Other features of the sensor, supported by the platform, will be available
in the near future.
Figure 10 Smoke Sensor preferences page