DWELL - The amount of time the solenoid is energized each time the marker is fired. Too low of a dwell setting may lead to inconsistency or
drop off. Too high of a dwell can cause bad air efficiency.
Default: 16
BALL IN PLACE (BIP) DELAY - This setting is referred to as the “bounce detector” setting and is designed to help prevent chopping in the
breech as the last paintballs in the loader “bounce” in the breech. PRO TIP for BIP DELAY setting: If you commonly break or chop the last ball
or two in your loader, raise your BD DELAY setting higher than the factory DEFAULT setting.
Default: MID HI
EYE POWER - The Eye Power setting adjusts the intensity of the eye beam. The higher the setting is set the more resistance the eye puts on
the beam. If your marker reads that there is a ball in the breach but will not fire you should increase this setting.
Default: Mid Lo
DEBOUNCE - This setting controls the read-rate of your trigger pull and can be thought of as trigger bounce sensitivity. Lowering your
D-BOUNCE setting can result in higher rates of fire (trigger/micro-switch bouncing), especially in SEMI-AUTO/UNCAPPED fire mode. Raising
your D-BOUNCE setting can help to eliminate “runaway trigger” or excessive “trigger/micro-switch bouncing”
Range of Adjustment:
Default: 2
RAMP START - The number of trigger pulls required to start ramping.
RAMP KICK IN (ROF) - The rate of fire that must be achieved to begin ramping.
RAMP SUSTAIN (ROF) - The rate of fire needed to sustain ramping.
ANTI BOLT STICK (ABS) - This setting will increase the dwell setting when the gun is left for a certain amount of time (adjustable in “ABS
time”. This setting should be set at a higher dwell time than the current dwell setting. If you experience first shot drop off and basic engine
maintenance does not fix it try increasing this setting. This setting will not affect the velocity.
Default:4
ANTI BOLT STICK (ABS Time) - This setting controls the amount of time the gun can rest before the ABS Dwell kicks in.
Default: 30 seconds
Chirp- This setting controls weather the speaker is ON or OFF.
Default: ON
CHIRP - This setting controls whether the speaker is ON or OFF.
Default: ON
SHOT COUNTER - This keeps track of the amount of shots the gun has fired with or without paint. You can reset the counter by selecting it in
the settings menu.
GAME TIMER - The Field One Force comes with a game timer built into the Force BLU18 board. The user will be able to set the timer to a
specified amount of time and then start the timer with a trigger pull at the beginning of a game or match. To access the TIMER SCREEN
before a game or match, press and hold the power button for 1.5 seconds. Once TIMER SCREEN is displayed on the OLED screen, you can
start the timer by pulling the trigger once. Once the timer has been started, the time remaining will be displayed on the OLED screen on the
grip frame. To reset the GAME TIMER, press and hold the power button for 1.5 seconds. This will also return you to the HOME screen.
TEXT ORIENTATION - This setting will allow right-handed and left-handed users to switch the orientation of the OLED text to best suit how
they like to hold the gun while adjusting settings.
Default: Right Hand text
FACTORY RESET - This will restore the Field One Factory settings.
CAUTION: READ AND FOLLOW ALL SAFETY GUIDELINES AND WARNINGS BEFORE HANDLING OR
ATTEMPTING ANY WORK ON YOUR FIELD ONE PAINTBALL MARKER. SHOULD YOU BE UNSURE AT ANY
POINT, STOP AND GET HELP FROM A FIELD ONE PAINTBALL CERTIFIED TECHNICIAN.
To Next Page
Loading...